Cristobal® +

Inlays & Onlays | Crown & Bridge | Maryland Bridges


INLAYS & ONLAYS

Try-In Paste (Optional)

  1. Apply Try-In Paste to the restoration. Seat the restoration, check the color and then remove it.
 

Clean and Dry (Optional)

  1. If Try-In Paste has been used, thoroughly clean all internal surfaces of the restoration with water spray and air dry.
 

Apply Silane

  1. Apply Caulk Silane Coupling Agent to the bonding surfaces of the restoration according to instructions.

Tooth Conditioner

  1. Apply Caulk 34% Tooth Conditioner Gel to available enamel (and dentin if desired) for 15 seconds. Rinse for 10 seconds. Blot dry to keep moist, do not rub.

Mix Prime & Bond® NT™ Dual Cure

  1. Place 1-2 drops of adhesive and an equal number of drops of Self Cure Activator into a mixing well and mix with a new brush tip.

Apply Bond to Tooth

  1. Apply Prime & Bond NT Dual Cure mixture to thoroughly wet the tooth surfaces. These surfaces should remain wet for 20 seconds, which may necessitate additional adhesive. Gently air dry for five seconds. Surface should have a uniform, glossy appearance. If not, repeat application. Light cure Prime & Bond NT Dual Cure for 10 seconds.

Apply Bond to Restoration

  1. Apply a single coat of Prime & Bond NT Dual Cure mixture to the bonding surfaces of the restoration. Immediately air dry for five seconds.

Mix Calibra

  1. On a mixing pad, dispense equal amounts of the desired shade of Calibra base and REGULAR OR HIGH VISCOSITY catalyst. Mix 10-20 seconds until uniform.

    Minimum work time: 2 minutes 30 seconds.

Apply Calibra

  1. Apply a thin layer of cement to all bonding surfaces of the restoration.

    TIP: Sometimes it's easier to apply a thin layer of cement to the internal portions of the tooth preparation to avoid any porosity or voids.

Seat

  1. Seat the restoration slowly. Maintain downward pressure and remove excess cement from marginal areas with a dry brush.

Pre-Cure

  1. A 10-second light "Pre-Cure" at the margins will "gel" the excess cement for easy clean-up.

Remove Excess

  1. Lift off the excess cement around the margins.

Light Cure

  1. Once stabilized, light cure all marginal areas for 20 seconds from the buccal, lingual and occlusal aspects.

    Apply moderate pressure throughout the 6-minute self-cure set time.

Finish

  1. Complete all finishing and polishing with the Enhance® System.

Reprinted with permission of Denstply International. Cristobal + is a registered trademark of Dentsply International.

Return to Cristobal®+ product page